Coprinus comatus summer off-season cultivation
Coprinus is a moderate temperature variety, and it is suitable for mushrooming when the temperature is 12-25°C. Under natural conditions, it is generally best to produce two seasons from March to May and from September to November. However, as long as the biological characteristics of coprinus comatus are grasped and the conditions required for its growth are met, in the summer, fresh and delicious coprinus comatus can be produced, which will yield extremely high economic benefits. First, the construction of bacteria The scale of cultivation area is preferably 300-1000 square meters per square meter. Dig deeper than 0.2 meters, 1.4 meters wide and 20 meters long. The gap between bacteria and sclerotinia is more than 0.8 meters, and a work lane of 4 to 6 meters wide is reserved every 6 miles to facilitate the entry and exit of vehicles. A cultivated field with an area of ​​less than 500 square meters does not need to leave a wide working path. Second, take a awning A shade awning is erected 2.5 to 3 meters above the cultivator to require the awning to be closed and opaque. The shed was covered with a layer of plastic film to prevent rain, and a shade net was placed over it. The perimeter of the awnings is better than 3 meters around the cultivation field, so that the sunlight from 9 to 16 hours is not direct. Planting long vine plants around the shed, especially long gourd gourd, chayote, gourd, pumpkin is appropriate to increase the shade effect. Three, moisturizing and moisturizing Spray pipes and one-way spray heads are installed above the awnings, and a row of double nozzle pipes are installed every 4-5 meters in the awnings. The role of the spray head is to spray water and moisturize the space in the sun shade. The installation of the device should be tested in the field so that the spray does not leave dead angles. The surrounding piping should be provided with a valve on each side in order to close the nozzle at the bottom when there is wind. Fourth, pest control measures A worm-proof net is placed around the awning to prevent entry of various insects. V. Covering materials Fertilize the fertile soil in a fertile garden soil or vegetable greenhouse and add fermented cow dung, 200 kg of chicken manure and 10 kg of urea per 1000 kg of soil. After mixing well, 600 times of phoxim solution was sprayed and then covered. About 5-7 days later, open the mound, add 30 kilograms of lime powder, mix well and build a heap, cover the membrane, and use it after 7 days. The earth-covering material can be prepared with a 2 m2 earth covering amount per 100 m2 of trampoline. Sixth, cultivation and management The processing of the base material is carried out according to a conventional method, and bagging and germs are required. Should create conditions to extend germination time, generally must be extended for more than 30 days, and then remove the bags into the earthworm and cover soil according to conventional methods. Under natural temperature conditions, maintain 80% of the average relative air humidity under the awning. Seven, matters needing attention First, the relative humidity of the air under the awning can not be too high, the highest 95% in the middle, the relative humidity can be maintained at about 75%; second, spray moisturizing to be repeated several times, as little as possible to accumulate water beads on the fruit body; Third, the thickness of the earth covering is 2 cm, but if you want to produce big coprinus comatus, you can cover it to 4–5 cm. Fourth, when the natural wind is large, you can install wind shields on the side of the wind awning. Grasshopper or plastic film. No measures can be taken when wind level 3-4. 1000Hz High Frequency LiDAR System JRT High Frequency Range LiDAR Sensor is 2021 new product, that's a low-cost tof sensor but High frequency (up to 1000Hz). With 5cm high accuracy, the LiDAR Module can measure 80m.
Chengdu JRT Main Ranging Modules: Industrial Laser Distance Sensor, Laser Distance Meter Module, Tof LiDAR Sensor. lidar sensor,tof sensor,lidar system Chengdu JRT Meter Technology Co., Ltd , https://www.infrareddistancesensor.com
Why the 1000Hz High Frequency LiDAR System:
* Widely used in many industrial automation system, like, UAV, delivery van, anti-lock break system, construction automation,intelligent toy robots etc.
* Small size: 43*35*21mm, can be easily integrated
* Invisible laser design: the laser type is 905nm,Class I
* High Frequency: 1000hz/1khz
* Low power design
