The common faults and maintenance of miniature electric self-priming pump

1. The motor part (1) does not respond after turning on the power. Most of them are caused by power plugs, power outlets and motor windings. (2) Difficult to start or unable to start, accompanied by a "squeaky" sound. During inspection and repair, small bamboo strips can be used to rapidly move the blades according to the running direction. If the motor is quickly operated, it indicates that the starting capacitor or starting winding is damaged. Replace the capacitor with the same capacity or repair the starting winding. If the motor is issued, the motor and the pump head are mostly. Mechanical failure, such as bearing damage, stuck impeller and so on. (3) The motor can run, but the speed is slow, and the casing is overheated and burnt. Most of them are caused by the short circuit of the motor windings. They should be repaired by taking measures such as welding, jumper, isolation, and rewinding, depending on the damage of the motor. (4) Large noise and large vibration during operation. Most of the bearings are damaged or the bearing and the chassis are not properly mated. The motor must be dismantled and inspected. If the bearing is “out of circle”, the mating surface of the pump casing can be used to decorate it; if the bearing “runs inside "Circular" can be used to decorate the worn part of the motor shaft. The wear is serious and it is repaired by lathing after welding. 2. Pump head part (1) The motor runs normally but there is little or no water at all. This situation should first check the seal of the pump, check the power plug should be unplugged, hand plug the suction port, fill the water pump, with the mouth to seal the exit and blow in the air, observe the pump head is leaking, leaking The place is where the seal is damaged. Common faults include suction pad, outlet pad, and impeller cover pad, which should be replaced during maintenance. If there is no full water phenomenon, the impeller is damaged, the water-retaining partition between the water-absorbing chamber and the outlet chamber is worn out, the pump head is covered with water, and the gap between the impeller and the pump casing is increased. The impeller and the pump casing should be replaced. . When replacing the rake wheel, care should be taken to completely remove the remaining copper blades in the pump so as not to damage the new impeller again. (2) Enclosure is charged. Most of the damage is caused by the water seal and the penetration of water into the motor through the motor shaft deteriorates the insulation performance of the motor. Can be replaced by water seal, drying motor and other methods to repair. It should be noted that because the water pump is exposed to water for a long time and it is open to work in the open air, it is easily affected by moisture and deteriorates the insulation performance. In order to ensure personal safety, the electric self-priming pump should be reliably grounded; in winter, the water in the housing should be used up to keep warm and other measures To prevent freezing the chassis.

Organic Isomalto-Oligosaccharide 900 (corn) Powder

Isomalto-Oligosaccharide Aliments,Organic IMO,Corn IMO

Qingdao Bailong Huichuang Bio-tech Co., Ltd. , https://www.qdblcycn.com