Cyclone separation and crushing equipment instruction manual
Shanghai Rocatti Biotechnology Co., Ltd. is a professional enterprise of rehabilitation and medical device products with sales and service as the main body. Since its establishment, the company has been committed to the development of medical devices. Its products involve the production of epidemic prevention materials such as gynecology (obstetrics), Urology, neurosurgery, kn95 medical protective masks, daily use flat masks, and the research and development of total nutrition slimming food. It can provide a complete range of first, second and third class medical device configuration schemes for general hospitals and specialized hospitals.
Nonwoven Face Mask,Non-Woven Facial Face Mask,Non-Woven Face Mask Ffp2,Non-Woven Surgical Face Mask Shanghai Rocatti Biotechnology Co.,Ltd , https://www.ljdmedical.com
â—† Start idling to check if the cutter is turning correctly. If the direction is reversed, please change the wiring sequence of the three-phase power cable. After confirming that the cutter is turning correctly, start the idle rotation for 10 minutes. After all the normal, you can feed the production.
â—† It is forbidden to put iron and other hard objects into the crushing room.
â—† When an abnormal sound is found, stop it immediately, check the cause, and restart the machine after troubleshooting.
â—† It is recommended to install the machine in a separate workplace.
Cyclone separation and pulverizing equipment maintenance â—† The mechanical starting motor should be turned to the ventilation position to ensure the heat dissipation of the motor and prolong the life of the motor.
â—† Regularly check the tool bolts. After a new one, use a special tool to tighten the moving bolts to strengthen the fixing between the blade and the tool holder.
â—† Rolling bearing with seat: At every interval, grease should be added to the bearing grease to ensure the lubrication between the rolling bearings.
â—†According to the use situation, check the moving knife regularly to ensure the sharpness of the moving knife and reduce the unnecessary damage of other components caused by the blunt blade.
â—†Before the second start, the remaining materials in the machine room *breaking should be removed first, reduce the starting resistance and reduce the starting load of the motor. The inertia wheel cover should be dismantled regularly to remove the ash outlet under the belt pulley.
â—†When changing the tool, keep the gap between the movable knife and the fixed knife.
â—† Regularly check if the belt is slack. If the belt is slack, loosen the motor fixing bolt and use a special tool to move the motor outward until the belt is tightened.
Precautions for use of cyclone separation and crushing equipment â—† Before starting the crusher, turn on the main power switch and confirm the power supply. Turn on the circulating cooling water and confirm the water flow.
â—† Before the crusher is turned on, first open the pump for 5 minutes, then open the discharge valve of the storage tank, discharge the waste material in the storage tank, and then press the start button of the crusher to open the broken machine.
â—† The loading amount in the storage tank should not be too much. When the storage capacity reaches 1/2 of the barrel, it must be discharged. Otherwise, too much storage will cause difficulty in pumping the fan, and the fan will not be able to discharge the scrap in the crusher, which may cause serious problems such as the fan motor burning and the crusher being stuck.
â—† When the crusher stops, please stop the crusher first and wait for 10 minutes. After the crushed material in the crusher is evacuated, and the stock in the storage tank is discharged, the power of the pump is turned off.
â—† Before turning on the power again, please repeat the above item 1 as required.
â—† The dust inside the bag on the storage bin needs to be cleaned. It is recommended to clean it every three days to keep the bag ventilated smoothly.
â—† It is recommended to fill the bearing butter once every two months. Turn off the circulating cooling water first, then unscrew the four bolts on the bearing cap and open the bearing cap to refuel. After the butter is filled, please pay attention to tighten the bearing cap bolts.
