Milking equipment cleaning and maintenance
Every time the cleaning components are milked, all components passed by the milk should be cleaned. Cleaning method: Rinse with clean water first, then put it in hot detergent (temperature of 70°C, containing 1% of alkali), wash it with a brush, and finally clean it with 80°C hot water, and dry it for use. Clean and inspect the rubber sleeve inside the rubber sleeve. The rubber sleeve should be removed for cleaning. However, it must be prevented from being deformed due to the high water temperature. At the same time, it is necessary to check whether the rubber sleeve is intact and if any leakage is found, replace it immediately. After the collector of the milk collector is cleaned, it should be checked whether the rubber gaskets are intact and whether the holes on the four walls are open to the atmosphere. Prevent the glass test tubes from damaging the glass test tubes and the access switches on the lid of the milk canister. Care must be taken to avoid damage during the cleaning process. Do not leak gas after assembly. Repair the pulsator pulsator and vacuum hose once a week, and check the pulsator rubber film is intact, the wall of the hole is open to the atmosphere. After assembly, adjust the pulse frequency at 40-70 times per minute for use. The pulsator refueling needs to be carried out according to the supplier's requirements. Replace milk tubes in time to replace milk tubes in time. Otherwise, on the one hand, milking is difficult because of its poor elasticity, and on the other hand, any tiny cracks on the surface will have residual milk scales, providing conditions for the propagation of bacteria. Check the milk pump check valve once a week if the diaphragm of the check valve breaks, air will enter the milk pump, and there should be a milk pump check valve. Monthly inspection Clean the vacuum regulator, sensor and vacuum pump belt Wipe the vacuum regulator valve and seat with a damp cloth at a time, wash the sensor filter with soap solution, dry it and then install it; press the belt with the thumb should be 1.25 cm Tension, belt wear or damage should be promptly replaced. After replacing or adjusting the belt, check whether the two wheels are in a straight line. SICHUAN UNIWELL BIOTECHNOLOGY CO.,LTD. , https://www.uniwellbio.com